Yes, most of the documentation is only available in Russian, but that will hopefully change in a near future.
(and, btw, I've also pulled my hair out while trying to understand the VKB Device Config
)
About connecting the T-Rudder to the Gladiator, I've only used the VKB Config Device until a few minutes ago, and WIZZO does the exact same job.
Here's what I've done (with the default profile, so the pedals axis is already pre-configured):
- unplug the Gladiator
- connect the pedals to the Gladiator
- plug the Gladiator back in
- start WIZZO and calibrate (start/move the axes/stop)
- kiss it goodbye (close)
- done
For whatever reason, WIZZO does not display the changing axis values (when I move the controls) right after I stopped the calibration. You can just close it and restart it, and you'll see your axes behaving as expected.
(and of course: no need to keep the TinyBox connected)
Now you just have to assign your axes in the sim of your choice and you're good to go.
My pedals axis is inverted when connected to the Gladiator. I don't know if it will be the same for you, but you can invert the axis using WIZZO (reverse switches) if it's required (don't forget to apply your settings) (the same thing can be achieved with the VKB Device Config).
Happy flying in RoF