VKB-SIM

Good Morning
Been out of the flight sim arena for some time and have just rediscovered it again.
I just ordered the Stecs Std MkII with FSM-GA and GNX-SEM-V
My question... is it possible to wire them all together with the jst connectors and only have one usb plug to computer?
I also bought the USB conversion adaptor in case this was not possible.

Thanks in advance
Rocket

You can connect either the FSM or the SEM to the STECS by the included USB C to USB C cable (both FSM and SEM-V come with one of these). For the second device there are 2 options: either upgrade it with a GNX HID Controller and use it as an independent USB device or get a JST to USB cable to connect it with the other 2 units. You will need some kind of mounts for this setup, as these 3 devices can't get attached to one another.

Fallout...Thank-you for your time. First hurdle cleared, lol...Im use to an MS sidewinder stick and an X-52 throttle.

Would I pull them out of box , wire them together, and then go through Calibration process? Ive watched a bunch of youtube
and Im still not 100% sure on that process.

RocketC

Once connected as explained, you'll need to run VKBDevCfg, select the device at the top and click the Default button under the Tools tab. If you'll get a popup asking to configure, click Yes. Click Yes when the calibration popup/dialog pox comes up, calibrate, click the End Calibr button when done and that's it.