Connecting FSM-GA to Gladiator NXT EVO Base
Posted: Wed Jan 21, 2026 19:12
by Herk4402
How can I connect the FSM-GA to the Gladiator NXT EVO Premium Base? I have the GNX Module-to-Module Interface Cable (Type-C to JST2.0-4). Not sure which 4-pin to connect the JST plug to. Configuration help would be appreciated as well.
Re: Connecting FSM-GA to Gladiator NXT EVO Base
Posted: Wed Jan 21, 2026 21:52
by fallout9
JST plug into the Gladiator base, like below; USB C into the FSM-GA.
Run VKBDevCfg, select the Gladiator at the top, click the Default button under the Tools tab.
Click Yes at the configure popup after restart.
Click Yes to the calibration popup after a second restart.
Calibrate by moving all axes on the Gladiator through their whole range.
Click End Calibr button when done.