VKB-SIM

Posted: **Tue Mar 25, 2025 20:21**

When connecting GNX-THQ with Flightstick.

Failed:
- On GNX-THQ axis x does not work.
- On Flightstick axis z (left/right) does not work.

Note: Connected with 4 pin cable.

: Failure in Flightstick

: Configuration GNX-THQ

: Configuration Flightstick

: Failure in GNX-THQ

: Wired connection between components

Posted: **Tue Mar 25, 2025 22:25**

Please use the 3 wires cable to connect them. Plug the 3 pin connector into the Gladiator's 4 pin socket like shown here.
Reset to default and initialize after plugging back to USB.

Posted: **Wed Mar 26, 2025 1:20**

It also fails with a 3-pin connector.

It worked after changing the firmware to version _Gladiator_EVO_v2_18_D.vkd.

However, with the old firmware, the Z axis doesn't reach the maximum value.

Posted: **Wed Mar 26, 2025 8:47**

Switch your firmware version. 2.18.9 has issues with axes when a THQ is connected.

VKB-SIM

Failed GNX-THQ + Flightstick (in gnx-thq axis x, in flightstick axis z left/right)

Failed GNX-THQ + Flightstick (in gnx-thq axis x, in flightstick axis z left/right)

Re: Failed GNX-THQ + Flightstick (in gnx-thq axis x, in flightstick axis z left/right)

Re: Failed GNX-THQ + Flightstick (in gnx-thq axis x, in flightstick axis z left/right)

Re: Failed GNX-THQ + Flightstick (in gnx-thq axis x, in flightstick axis z left/right)