VKB-SIM

Software: 0.93.21
Firmware: 2.18.F

Issue: In the Curve Wizard, manually trying to drag up a control point with value zero in Proportional or Square Linked mode results in a 'Floating point division by zero' error. The control point will not move.

• Bezier has no problem moving a zero-value control point.

Bumping this as it's still current with software version 0.93.89. I realize I was less than thorough with the step by step in the original post:

1. In Profile > Axis open the Curve Wizard for any curve
2. Enable Proportional
3. Drag the last control point (100% deflection) all the way down to zero: all the points should be at zero
4. Click OK to close the wizard
5. Open he curve wizard again for the same curve
6. Try to drag any point up from zero to receive 'Division by zero' error.

Thanks, fixed.
Although dropping the curves to zero and then restoring linked curve is in itself meaningless (by existing linked algorithm).