VKB-SIM

Hey hey,

Trying to change all the button LEDs on the SEM to blue when Shift 1 is active

I have it set up as attached, but when I switch into shift 1 with the mode dial set to 3, the LEDs only get brighter green, any thoughts?

The button LEDs only have green and red color. There is no blue emitter.

Setting Color1 to red still makes everything just brighter green, not red when Shift 1 is active.

Add lines like here. After that in the Test-Misc tab in the lower right corner in the Led N window put numbers, you can start with 0 and hold down the FastTest button. As a result, you will be shown the placement of the Led and its possible colors. They may not match the color in the configurator, just consider that these are Color1 and Color2. After that, you need to restart the controller.

HooverinSchneef wrote:Setting Color1 to red still makes everything just brighter green, not red when Shift 1 is active.

Use Color2 then. Bi-color LEDs work a bit differently than RGB LEDs.