Hey hey,
Trying to change all the button LEDs on the SEM to blue when Shift 1 is active
I have it set up as attached, but when I switch into shift 1 with the mode dial set to 3, the LEDs only get brighter green, any thoughts?
NXT-SEM LEDs based on shift state
Moderator: AdminGroup
-
- Posts: 11
- Joined: Tue Feb 01, 2022 19:14
Re: NXT-SEM LEDs based on shift state
Setting Color1 to red still makes everything just brighter green, not red when Shift 1 is active.
-
- Posts: 3542
- Joined: Tue Jan 15, 2013 23:56
- Location: г.Минск
- Has thanked: 46 times
- Been thanked: 690 times
Re: NXT-SEM LEDs based on shift state
Add lines like here. After that in the Test-Misc tab in the lower right corner in the Led N window put numbers, you can start with 0 and hold down the FastTest button. As a result, you will be shown the placement of the Led and its possible colors. They may not match the color in the configurator, just consider that these are Color1 and Color2. After that, you need to restart the controller.
Re: NXT-SEM LEDs based on shift state
HooverinSchneef wrote:Setting Color1 to red still makes everything just brighter green, not red when Shift 1 is active.
Use Color2 then. Bi-color LEDs work a bit differently than RGB LEDs.
Who is online
Users browsing this forum: No registered users and 11 guests