VKB-SIM

I've been using zlink to connect an SEM to a MCG Pro on GF3 base, and the shift function has been working perfectly. However subshift is not picked up by the MCG, although it is recognised by zlink. Pics off settings attached. Any ideas?

That is a fairly large firmware discrepancy. I am not usually the person who recommends updating, but...

Wait, you are the person who downgraded for stability reasons. I do not want to send you on a hunt for the perfect firmware, but I would like to check if subshift over vkb-link works with something like 2.17.6 before I ask you to try whether your SEM works with that. Might be a while until I get around to testing that, though.

Yeah, SEM has issues with current firmware so rolled back, but sS on zlink didn’t work with the SEM on 2.165 firmware either.

Spent a bit more time on this, there is no combination of my three devices as slave/master where subshift works over zlink. Using version 0.72 or 0.75. Subshift works fine on a single device.

i have a similar issue, where can i get the older firmware?

Which issue are you having and which firmware are you on?

Please be kind enough to read the programmer’s request; without its implementation, it is unlikely that the problem can be solved.