Black Box Mk3 LED #1 blinking red
Posted: Wed Apr 24, 2024 19:20
Greetings
My setup is as follows:
Right handed GF4 SCG -> A1 mini stick replaced with provided hat switch
Left Handed GF4 SCG -> stock config.
T-Rudder pedals mk5 I have yet to plug in.
All of these are plugged into a powered USB Hub that plugs into PC
Configuring and calibrating the left stick went without issue following this video https://www.youtube.com/watch?v=2KWjBe5UxSQ
Configuring the right stick however cannot proceed because upon plugging in the power the #1 LED on the right side of the black box blinks red. #2 is a solid green, #3 is off and the Sys LED blinks from blue to red intermittently.
The stick is well seated and secured on the base. I have tried changing USB ports and even changing black boxes ( have one spare since I have yet to configure the pedals) with the same results.
Do I have a beautifully engineered paperweight on my hands ?
My setup is as follows:
Right handed GF4 SCG -> A1 mini stick replaced with provided hat switch
Left Handed GF4 SCG -> stock config.
T-Rudder pedals mk5 I have yet to plug in.
All of these are plugged into a powered USB Hub that plugs into PC
Configuring and calibrating the left stick went without issue following this video https://www.youtube.com/watch?v=2KWjBe5UxSQ
Configuring the right stick however cannot proceed because upon plugging in the power the #1 LED on the right side of the black box blinks red. #2 is a solid green, #3 is off and the Sys LED blinks from blue to red intermittently.
The stick is well seated and secured on the base. I have tried changing USB ports and even changing black boxes ( have one spare since I have yet to configure the pedals) with the same results.
Do I have a beautifully engineered paperweight on my hands ?