GNX-THQ left slider lack of sensitivity

[Benirock]

Hi all!

I'm having troubles with the left slider of my GNX-THQ module.
It seems to be less sensitive than the other two (middle and right sliders) and not responding to small inputs.
In DCS, this for example translates into imprecise throttle management, which was exactly what I was trying to correct when I bought this module.

The problem can be seen in the VKB joytester (see image below) when moving the left and the middle slider together.
With fast oscillating movements, we can see precise fluctuations of the middle slider (Slider2) while the left slider (Slider1) barely respond.
With slower movements, we can observe a delay in the left slider response as compared to the middle slider.

Do you have any idea where the problem might be coming from?
Do you think there could be a hardware problem (e.g. detector) with my left slider?
I have of course calibrated my device and all other aspect of my VKB setup (EVO R + SEM + THQ) work like a charm.

Thank you in advance for your answers, any help would be greatly appreciated.

Ben.

[Delta]

Would be curious if there are different filter settings on the profile/axes/physical tab.

[Benirock]

Thank you for your answer.
Here is a screenshot of my profile/axes/physical tab.
Let me know if you need anything else to to make a diagnosis.

[Ron61]

Reset to default and recalibrate these axes.

[Benirock]

This is what I tried first and it didn't work.
I just did it once again this evening (to be sure) but no improvement unfortunately.