hardwiring a module to left side OTA stick
Posted: Fri Mar 15, 2024 18:09
Hi,
i just got my Gladiator NXT & NXT OTA in today, i ordered an extra module to pair with them and was wondering a bit about the setup of these
i would like my side extension module to be attached to my left (OTA) stick, to the right of the stick, firstly i was wondering if this is possible (as i read up on this, it seems it might not be?)
secondly, if it were possible i'm a bit confused with the pins to connect, i have 2 little JST cables, a 4 to 4 and a 4 to 3, however in both the module and the stick it seems i only have connection points with 4 pins
should i use the 3 pin, on a 4 pin connector? should this be on the "top half" of this 4 pin, or should it be on the bottom half of it?
also was wondering if the USB-C cable (which didn't come with the module, which i didn't notice) has to still be attached if i hardwire these 2 modules together with the JST cable?
sorry for the questions, excited to get started and struggling to figure it out
kr,
Twiddin
i just got my Gladiator NXT & NXT OTA in today, i ordered an extra module to pair with them and was wondering a bit about the setup of these
i would like my side extension module to be attached to my left (OTA) stick, to the right of the stick, firstly i was wondering if this is possible (as i read up on this, it seems it might not be?)
secondly, if it were possible i'm a bit confused with the pins to connect, i have 2 little JST cables, a 4 to 4 and a 4 to 3, however in both the module and the stick it seems i only have connection points with 4 pins
should i use the 3 pin, on a 4 pin connector? should this be on the "top half" of this 4 pin, or should it be on the bottom half of it?
also was wondering if the USB-C cable (which didn't come with the module, which i didn't notice) has to still be attached if i hardwire these 2 modules together with the JST cable?
sorry for the questions, excited to get started and struggling to figure it out
kr,
Twiddin