Hi,
i just got my Gladiator NXT & NXT OTA in today, i ordered an extra module to pair with them and was wondering a bit about the setup of these
i would like my side extension module to be attached to my left (OTA) stick, to the right of the stick, firstly i was wondering if this is possible (as i read up on this, it seems it might not be?)
secondly, if it were possible i'm a bit confused with the pins to connect, i have 2 little JST cables, a 4 to 4 and a 4 to 3, however in both the module and the stick it seems i only have connection points with 4 pins
should i use the 3 pin, on a 4 pin connector? should this be on the "top half" of this 4 pin, or should it be on the bottom half of it?
also was wondering if the USB-C cable (which didn't come with the module, which i didn't notice) has to still be attached if i hardwire these 2 modules together with the JST cable?
sorry for the questions, excited to get started and struggling to figure it out
kr,
Twiddin
hardwiring a module to left side OTA stick
Moderator: AdminGroup
-
- Posts: 3280
- Joined: Tue Jan 15, 2013 23:56
- Location: г.Минск
- Has thanked: 45 times
- Been thanked: 637 times
Re: hardwiring a module to left side OTA stick
There are inscriptions near the connector that will help you figure out how to connect the connector. In 4 pins you can connect 3 pins, Shield (Sh) will remain free.
Who is online
Users browsing this forum: No registered users and 16 guests