FSM-GA ,need JST2.-4 interfacee cable for standalone ?

[MadMac0891]

So i've ordered a FSM-GA with GNX USB controller (HID-main) a couple of days ago.
These will be delivered today.

Yet this morning I was thinking I forgot something :
I want to use the FMS-GA as standalone (I got no other VKB device's so the FMS-GA will get connected to the PC)

But to use the FMS-GA like this, I'd probably need the GNX BUS (Type-C)-JST2.0-4) interface cable ?
(Which i didn't order)
If I'm correct a JST2.0-4 interface cable isn't included with the FSM-GA or USB controller ?

As I understand the connecting the FSM-GA to PC without other VKB devices would look like this :
FSM-GA -> GNX BUS (Type-C)-(JST2.0-4) interface cable -> GNX USB controller (HID-Main) -> type-C USB cable -> PC

[Delta]

The GNX USB controller gets installed into the FSM-GA without additional cables. The cable is only required when you want to run the FSM off something like a single SEM or THQ.

[MadMac0891]

Then I misunderstood, thank you very much