VKB-SIM

Hi,

I started using my MCG Ultimate again and noticed that the X, Y and Z axis show inverted values if I go to near to the edge.
Moving beyond the shown maximum of 65535 reverts to a output of 0 and vice versa for all three axis.
The stick is used with a 200mm extension and twist module on a gunfighter mount and dual #40 springs for X and Y.
Already tried calibrating in the device config by moving all axis and sticks to every direction but it did not help, yet.

Thanks in advance for your help.

Show the Profile-Axes tab.

Hey Ron,
thanks for your reply.
I restarted and tried to calibrate again as an admin and it works now.