Hi,
I started using my MCG Ultimate again and noticed that the X, Y and Z axis show inverted values if I go to near to the edge.
Moving beyond the shown maximum of 65535 reverts to a output of 0 and vice versa for all three axis.
The stick is used with a 200mm extension and twist module on a gunfighter mount and dual #40 springs for X and Y.
Already tried calibrating in the device config by moving all axis and sticks to every direction but it did not help, yet.
Thanks in advance for your help.
MCG Ultimate axis limit
Moderator: AdminGroup
-
- Posts: 2
- Joined: Tue Feb 27, 2024 18:46
Re: MCG Ultimate axis limit
Hey Ron,
thanks for your reply.
I restarted and tried to calibrate again as an admin and it works now.
thanks for your reply.
I restarted and tried to calibrate again as an admin and it works now.
Who is online
Users browsing this forum: lucky6660 and 17 guests