MCG Ultimate axis limit

[Wolfmother]

Hi,

I started using my MCG Ultimate again and noticed that the X, Y and Z axis show inverted values if I go to near to the edge.
Moving beyond the shown maximum of 65535 reverts to a output of 0 and vice versa for all three axis.
The stick is used with a 200mm extension and twist module on a gunfighter mount and dual #40 springs for X and Y.
Already tried calibrating in the device config by moving all axis and sticks to every direction but it did not help, yet.

Thanks in advance for your help.

[Ron61]

Show the Profile-Axes tab.

[Wolfmother]

Hey Ron,
thanks for your reply.
I restarted and tried to calibrate again as an admin and it works now.