Gunfighter MK3 X and Y sensor errors with SCG Grip
Posted: Sat Jan 27, 2024 17:17
Hi,
I recently noticed that the X and Y sensors on my right stick have a lot of dropouts. I recorded the problem with the Virpil Joystick Tester software (see image 1). I drew circles with the right stick, and you can see a lot of jumps in the X and Y coordinates in the picture. For comparison, the same test with the right stick (see image 2). I was able to assign the cause of the error to the right SCG stick by swapping both bases and also connecting a KG12 to the right base. The error only occurs when the right SCG is connected. I completely disassembled and cleaned the right SCG, cleaned and reconnected all the connections between the boards. I can't visually detect any defects. I can rule out a connection problem between stick and base because I don't have any communication errors. I am grateful for all helpful ideas. Thanks
I recently noticed that the X and Y sensors on my right stick have a lot of dropouts. I recorded the problem with the Virpil Joystick Tester software (see image 1). I drew circles with the right stick, and you can see a lot of jumps in the X and Y coordinates in the picture. For comparison, the same test with the right stick (see image 2). I was able to assign the cause of the error to the right SCG stick by swapping both bases and also connecting a KG12 to the right base. The error only occurs when the right SCG is connected. I completely disassembled and cleaned the right SCG, cleaned and reconnected all the connections between the boards. I can't visually detect any defects. I can rule out a connection problem between stick and base because I don't have any communication errors. I am grateful for all helpful ideas. Thanks