Page 1 of 1
"one shot" on cyclic shift instead of rapid fire
Posted: Wed Jan 17, 2024 12:18
by analog
It seems by default when you assign and use a cyclic shift button, when you press it down it rapidly moves through all the shift modes. Is it possible to have it such that you press the cyclic shift button, and just have it cycle to the next shift layer until you release the button ?
Re: "one shot" on cyclic shift instead of rapid fire
Posted: Wed Jan 17, 2024 14:03
by Ron61
Show the settings from the configurator.
Re: "one shot" on cyclic shift instead of rapid fire
Posted: Wed Jan 17, 2024 14:31
by analog
The issue is now resolved after erasing and setting up the cyclic shift key from scratch. The behaviour is now the "one shot" kind. I must have had a screwed up config.
Thank you @Ron61