Z Axis on EVO Base INOP
Posted: Fri Dec 15, 2023 0:03
Hey all. I went in to recalibrate my sticks today and noticed the Z axis on my base is not functioning. It just shows zero no matter the position of the control and the software shows no movement. SW1 to the left of it and EN1 to the right of it function properly. Last time I calibrated my sticks, it worked fine. My firmware is up to date (v2.16.5). Any idea how I can figure out if this is a software setting/issue, or an actual hardware issue? I tried to reset to default but it still doesn't function. any thoughts/help would be appreciated.
Rolling the firmware back to v2.12.2 seems to have fixed the problem for now.
Rolling the firmware back to v2.12.2 seems to have fixed the problem for now.