VKB-SIM

Hi - here is my existing setup. I have been running it like this for the past few months without issues:

Right to left: Gladiator NXT EVO joystick, SEM (connected via JST), THQ (connected via JST)

I am trying to connect the FSM module via USB-C to the THQ, but it is not being recognized by vkbconfig, and doesnt seem to be getting power (no LEDs light when I press buttons etc.)

I have tried connecting the FSM to the SEM module instead, with the same results. Vkbconfig is only recognizing the joystick, SEM, THQ, but not the FSM. I have flashed to the latest firmware (2.165) and am using vkb device config v0.92.88

Please help!

After flashing you need to reset to default, then press Yes at the config popup. This will make the FSM to show up. Calibrate afterwards.

Tried that already - reflashed using the latest firmware, reset to default, hit 'Yes' at the config popup, and did not show up.

Screenshot of Profile/External please.

I think I got it working after unplugging and replugging every cable I could, will post here again if I have any other issues. Sorry for bothering you!

That's good news, thanks for the update.