Need help connecting FSM-GA to existing NXT EVO+SEM+THQ setup

[toasty]

Hi - here is my existing setup. I have been running it like this for the past few months without issues:

Right to left: Gladiator NXT EVO joystick, SEM (connected via JST), THQ (connected via JST)

I am trying to connect the FSM module via USB-C to the THQ, but it is not being recognized by vkbconfig, and doesnt seem to be getting power (no LEDs light when I press buttons etc.)

I have tried connecting the FSM to the SEM module instead, with the same results. Vkbconfig is only recognizing the joystick, SEM, THQ, but not the FSM. I have flashed to the latest firmware (2.165) and am using vkb device config v0.92.88

Please help!

[fallout9]

After flashing you need to reset to default, then press Yes at the config popup. This will make the FSM to show up. Calibrate afterwards.

[toasty]

Tried that already - reflashed using the latest firmware, reset to default, hit 'Yes' at the config popup, and did not show up.

[fallout9]

Screenshot of Profile/External please.

[toasty]

I think I got it working after unplugging and replugging every cable I could, will post here again if I have any other issues. Sorry for bothering you!

[fallout9]

That's good news, thanks for the update.