VKB-SIM

Hi, sorry for the noobie question, I buyed T-Rudders Mk.V and blackbox 3 yesterday.

It's all ok, pc recognize pedals without problems, I calibrated pedals, green light for T-rudders on blackbox but there are 2 red light blinking all time, is normal?
There's a possibility to turn off the other 2 input, or disable led? it's annoying...
On this blackbox is connected only 1 t-rudders, for now i dont need two other ports

thank you for the answers

Please run VKBDevCfg, select the rudders at the top, press the Default button under the Tools tab, then click Yes for the popup asking to configure the device. After restart, click the Start Calibr button, move the rudders up and down a few times, then click the End Calibr button. This should get your device properly configured and settle all those lights on your bb.

THANK YOU!
Now lights are gone! thanks again