Flashed BB MK3 on MCGU Incorrectly.
Moderator: AdminGroup
Flashed BB MK3 on MCGU Incorrectly.
I'm pretty sure I flashed the mk2 software on my mk3 BB. Now I'm unable to re-flash the correct firmware. I keep getting an error "device sig not correct - flash fail please check version of firmware file for this device". I've tried flashing MK3 firmware 2.16.6, 2.16.5 and 2.16.3 to no avail. Also when I did get the software to recognize my flight stick by flashing 2.15.0 it labeled it as t-ruddle not gunfigher. Please, any help would be appreciated.
- fallout9
- Posts: 5190
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: Flashed BB MK3 on MCGU Incorrectly.
Try once more to flash the attached firmware after unzipping it. If it still doesn't work run zBootloader in Admin mode, erase the Select File -> bit from the command line and instead type: save. Check the folder where zBootloader is, there will be a file with .op1 extension - zip it and upload it here please.
- Attachments
-
- _BlackBox_Mk3_Unified_v2_16_5(2).zip
- (79 KiB) Downloaded 31 times
Who is online
Users browsing this forum: No registered users and 102 guests