Gladiator EVO - Axis Z doesn't work in Firmwares >2.12

[lemmi]

not in v2.14 or v2.16.

Switching back to v2.12 - Axis Z (the middle of the base) works again.

[DeadWalking]

I have Z axis middle on the base of my EVO working on 2.14.A
Are you defaulting and calibrating after the firmware updates?

[lemmi]

yes i did.

But i have a SEM installed.

It works on my "old" Gladiator NXT with the KG 12.

[DeadWalking]

I am not sure what is going on there with the SEM attached.
I would have to do some adjusting of my setup to test it out with a SEM also.
I will try and get to that this evening for me, and see if I notice the same thing.
I might be able to see how it can be tweaked to fix the Z axis throttle paddle, or at least verify that it is failing to recognize the Z axis.

[lemmi]

Tried even with newer Firmware/Configurator of Mister Oz with no luck.

Anyone else with the same prob?

[lemmi]

with v2.16.6 (beta) it works again.

[DeadWalking]

Shoot sorry I forgot to get to check that adjustment on my setup and test it.
Glad it is working now for you though.

[lemmi]

other things don't work, so i had to switch back.