Howdy,
I just received the T-rudder mk5 which I want to use with my gladiator NXT evo. Currently the T rudder is successfully detected as a USB device, but I do not get any input in DCS. I checked the VKB device config and it seems the firmware on the T-rudder / blackbox is for the space gunfighter XT2 v2.151 (see attached picture), which I think is not correct?
I thought to update the firmware and try recalibrating, but searching the VKB download section the only firmware version I found was for v2.14A, which does not have an option for the blackbox mk III.
Am I missing something? Can you advise on how to proceed?
Thanks!
Firmware for T rudder mk5 / blackbox 3?
Moderator: AdminGroup
- DeadWalking
- Posts: 103
- Joined: Fri Jun 24, 2022 4:51
- Has thanked: 66 times
- Been thanked: 15 times
Re: Firmware for T rudder mk5 / blackbox 3?
Default and calibrate in VKBDevCFg if that doesn't work then follow the default and calibration procedure for other BB3 devices.
Same as the Gunfighter IVs process.
https://youtu.be/2KWjBe5UxSQ
Shouldn't need to flash.
Just need to get defaulted correctly.
If you end up doing the SYS button on the BB3 method, be sure to finish the calibration before doing a calibration in VKBDevCFG.
Same as the Gunfighter IVs process.
https://youtu.be/2KWjBe5UxSQ
Shouldn't need to flash.
Just need to get defaulted correctly.
If you end up doing the SYS button on the BB3 method, be sure to finish the calibration before doing a calibration in VKBDevCFG.
Who is online
Users browsing this forum: No registered users and 87 guests