VKB-SIM

Good morning
One question..
I v bought this stick also since last week
Yesterday I assembled the stick, than connected to the pc and the PC recognized directally the stick and try in IL2 GB setting main axes and buttons of the stick.
All seems to me works fine

So my question is:

If all work in IL2...I don t need to download from VKb site any firmware and make a calibration with VKB program right?


Suspecting missing something...I v tried cold start procedure by pressing all 3 main buttons on the base..
Seems work fine( had to reset Il2 comands)...
But a thing happens now, when I turn on pc...the joystick come not alive...have to plug again the joy in the pc every time to make it alive...same advice?

It needs calibration before use, do this:
- run VKBDevCfg as Admin, select this device at the top, then press the Default button under the Tools tab;
- after the device restarts you'll get a popup asking you to configure, click Yes;
- after another restart click the Start Calibr button, move all the axes (pitch, roll, twist, minithrottle) and when done click the End Calibr button.

Try another USB port, directly to computer and see if it works this way.

Hi dwloaded VKBDevCfg from vkb site download section
But seems doesn t work, no one buttons clikable
In order to make working the vkbdevcfg I' v to download somethimg else?

Try to connect joystick