VKB-SIM

I have a GNX THQ + SEM modules and I tried updating my firmware to the latest. I was in the z bootloader and I loaded the "_GNX_USB_Controller_v2_14_A.vkb" flash file. As per suggestions, I removed the bottom plate and shorted the boot pins while unplugged from USB. While still shoritng the boot pins I plugged the device back in. I get a solid blue light, I can start the flash in zBootloader2.exe; however, I get different results each time. I have received CPU Error, Error data could not be erased, and what looks like success but then my module becomes unresponsive with no lights. This is using all the latest zBootloader and firmware from the VKB download section.

*I noticed a similar issue in the forum at this link: http://forum.vkb-sim.pro/viewtopic.php?f=25&t=7390&start=15

Try under a mainboard USB port, no hubs. Disconnect other USB devices, update your USB drivers, kill background running software, especially programs like Aorus, Razer, MSI, Logitech, Corsair, any LED management, antivirus, run VKBDevCfg and zBootloader as Admin. If still doesn't work try another computer.

I just tried turning off background apps and removing hubs. I am able to refresh. I received a message after flashing my device to reset the controller to restart the controller. At this point, there are no led's on the device. I have tried this on another computer with the same results. It seems the latest firmware has some compatibility issues. Is there an older version of the firmware that I can try? I don't see an archive of older Firmware versions.

Unzip and use this one please.

That worked! Thanks for your help.