VKB-SIM

Even after doing a default/calibration it still blinks. I probably flashed it with the wrong firmware, and I guess I am not knowing which one to flash it with.

It's a Gunfighter MK III according to the sticker on the bottom (with a twist).

Now nothing works accept the two axes, hates, twist nothing else works. Doesn't work in the calibration either. I've flashed this before, I have the Blackbox 2. I must mis-remembered which firmware to flash this with.

Please run VKBDevCfg and post a screenshot. Also, what grip do you have? If not sure, post a pic with your device.

Take'm apart and hold it straight up and spray wd-40 where these 3 connecting pins are. And push them in out until it's free and clean with a q-tip. Hope it'll help. P/s:
Remember to push down on the stick when you tighten the lock. .

WD-40 is overengineering IMHO)) Hold them tightly, fasten and check.