Even after doing a default/calibration it still blinks. I probably flashed it with the wrong firmware, and I guess I am not knowing which one to flash it with.
It's a Gunfighter MK III according to the sticker on the bottom (with a twist).
Now nothing works accept the two axes, hates, twist nothing else works. Doesn't work in the calibration either. I've flashed this before, I have the Blackbox 2. I must mis-remembered which firmware to flash this with.
After flashing Gunfighter MK III, red light blinks
Moderator: AdminGroup
-
- Posts: 8
- Joined: Mon Oct 05, 2020 17:30
- fallout9
- Posts: 5158
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 207 times
- Been thanked: 1217 times
Re: After flashing Gunfighter MK III, red light blinks
Please run VKBDevCfg and post a screenshot. Also, what grip do you have? If not sure, post a pic with your device.
-
- Posts: 2
- Joined: Wed Nov 17, 2021 12:09
Re: After flashing Gunfighter MK III, red light blinks
Take'm apart and hold it straight up and spray wd-40 where these 3 connecting pins are. And push them in out until it's free and clean with a q-tip. Hope it'll help. P/s:
Remember to push down on the stick when you tighten the lock. .
Remember to push down on the stick when you tighten the lock. .
Re: After flashing Gunfighter MK III, red light blinks
WD-40 is overengineering IMHO)) Hold them tightly, fasten and check.
Руководство пользователя по контроллерам VKB (VKB controllers User Guide) Ru&En
https://disk.yandex.ru/d/LlqiYtIrIetBOQ
https://disk.yandex.ru/d/LlqiYtIrIetBOQ
Who is online
Users browsing this forum: KoN and 19 guests