double rate function

Moderator: AdminGroup

pville_piper
Posts: 6
Joined: Sat Mar 04, 2023 18:18

double rate function

Postby pville_piper » Sat Mar 04, 2023 20:26

Trying to set up a double rate function as shown on page 83 of the manual.

button initial setup.
Image96

close the button down open it back up and the alternate action button displays
Image
buton profile
Image
the global setup
Image
when I do this the axis shows reduced output on the tester... but it's all the time, the button has no effect, what am I doing wrong?
Image

User avatar
Victorus
Posts: 1675
Joined: Wed Sep 21, 2011 13:25
Has thanked: 374 times
Been thanked: 257 times

Re: double rate function

Postby Victorus » Sat Mar 04, 2023 21:45

SW 0.92.76, FW 2.13e - works.
Руководство пользователя по контроллерам VKB (VKB controllers User Guide) Ru&En
https://disk.yandex.ru/d/LlqiYtIrIetBOQ

pville_piper
Posts: 6
Joined: Sat Mar 04, 2023 18:18

Re: double rate function

Postby pville_piper » Sat Mar 04, 2023 23:18

No change, latest firmware, defaulted, calibrated, re-assigned the button... no change

User avatar
Victorus
Posts: 1675
Joined: Wed Sep 21, 2011 13:25
Has thanked: 374 times
Been thanked: 257 times

Re: double rate function

Postby Victorus » Sat Mar 04, 2023 23:57

DR.jpg

dr_off_then on.jpg
Руководство пользователя по контроллерам VKB (VKB controllers User Guide) Ru&En
https://disk.yandex.ru/d/LlqiYtIrIetBOQ

pville_piper
Posts: 6
Joined: Sat Mar 04, 2023 18:18

Re: double rate function

Postby pville_piper » Sun Mar 05, 2023 0:17

I dont' see anything different if I have the if the alternate action box checked it will apply the setting, if it is unchecked, it won't change anything, the button does nothing pressed or un pressed with the box checked or uncheckedImage
Image

pville_piper
Posts: 6
Joined: Sat Mar 04, 2023 18:18

Re: double rate function

Postby pville_piper » Sun Mar 05, 2023 17:55

I knew it was something stupid, I had the wrong button, I watched the curves video again and saw the bit about using the poll check box to identify the button... Thanks for your patience Victor.


Return to “Technical Support”

Who is online

Users browsing this forum: No registered users and 30 guests