VKB-SIM

So I've got an intermittent issue were, every few minutes and for no apparent reason, my joystick is sending a "POV #1 Release" signal (according to the "log joystick" box in the VKB config tool). Interestingly, there's no corresponding input logged, e.g. "POV #1 = 0.0". It's *just* the "Release". Certain games are interpreting this is as a "POV #1 = 0.0", though, so it's still causing annoyances.

Device info is


and I've run the calibration, but the issue persists. Any suggestions?

Please post a screenshot with VKBDevCfg showing the Profile/AxesLogical and Physical Axes charts.

attached

There are new versions of firmware package and software and bootloader posted recently, please upgrade your current software and firmware, follow the software procedures of setting up the EVO and see if the problem persists.