Phantom signal from POV #1

[fitzbattleaxe]

So I've got an intermittent issue were, every few minutes and for no apparent reason, my joystick is sending a "POV #1 Release" signal (according to the "log joystick" box in the VKB config tool). Interestingly, there's no corresponding input logged, e.g. "POV #1 = 0.0". It's *just* the "Release". Certain games are interpreting this is as a "POV #1 = 0.0", though, so it's still causing annoyances.

Device info is

Code: Select all

Product Name:  VKBsim Gladiator EVO  R 
PRO version
T-Link  supported
Firmware version:  v2.115

and I've run the calibration, but the issue persists. Any suggestions?

[fallout9]

Please post a screenshot with VKBDevCfg showing the Profile/AxesLogical and Physical Axes charts.

[fitzbattleaxe]

attached

[fallout9]

There are new versions of firmware package and software and bootloader posted recently, please upgrade your current software and firmware, follow the software procedures of setting up the EVO and see if the problem persists.