Page 1 of 1
Device not detected after Firmware flashing the GNX WWII Throttle with GNX-SEM-V
Posted: Mon Nov 21, 2022 22:50
by WangoTango
Is this the correct file to flash ?
_GNX_USB_Controller_v2_11_5
Re: Firmware flashing the GNX WWII Throttle with GNX-SEM-V
Posted: Mon Nov 21, 2022 23:59
by WangoTango
Ok, I flashed this file and now my WWII throttle is not recognized in VKB Config software. It does not even show up at the top.
How do I get my computer to recognize my device again ?
Re: Device not detected after Firmware flashing the GNX WWII Throttle with GNX-SEM-V
Posted: Tue Nov 22, 2022 9:34
by WangoTango
Support is sending me a new HID control board to see if that sorts it.
Re: Device not detected after Firmware flashing the GNX WWII Throttle with GNX-SEM-V
Posted: Tue Nov 22, 2022 20:39
by WangoTango
BTW, use the Discord channel for quicker support.