VKB-SIM

Hello,

I've used the Gladiator NXT for a few weeks and love it. I decided to add a SEM and THQ with WWII grip. I've followed every single video and blog and downloaded the latest firmware and configurator. I set the THQ to use subaddress 4. All buttons work for me on NXT, THQ and SEM. However the throttle and remaining axis do not work on the THQ. I've spent about 8 hours trying to figure it out but I've exhausted my guesswork and patience.
I flashed the devices using the latest downloads. Oddly, the only one I could get to work set my device as EVO OT KG12 SEM THQ XT v2.115 ( I don't recall seeing EVO OT when I just had the NXT). After configuring, it's showing Err-Stat Active. I don't know what that means.

I've attached 6 screenshots of various Configurator screens hoping that helps assess my situation.

Thank You.

Looking forward to help.

M

Please upgrade your firmware like here: viewtopic.php?t=7120

Hello amd thank you for quick response.

Yes, I had read through that thread and followed the instructions. However, that version of the firmware will not work for me. I get the following message from the bootloader.

Just an fyi.

I've tried every flash file and the only ones that work are the two circled in red. I even tried what appear to be NXT files from Alex Oz's site.

M

I should also add that my NXT is the KG12 version with WWII grip.

Sorry, my mistake, that was for NXT, not EVO.
This is the right firmware for you:

That did the trick!

Phew. Thank you so much.

I will say though it took a few times of running Bootloader, defaulting, calibrating, etc to make it all stick. But in the end, it's working great.

Again, thank you so much for rapid response.

Glad it's been fixed, enjoy!