What gimbal parts for a Gunfighter Pro-L MCG Ultimate
Moderator: AdminGroup
What gimbal parts for a Gunfighter Pro-L MCG Ultimate
I have a Gunfighter Pro-L MCG Ultimate w/Built-in Twist Adapter. The gimbal came installed with AVIA-S cams. The quick guide states that a #10 – soft center detent cam is factory installed and #20 springs. I have #50 springs, but the extra cams are labeled “SPACE -S, SPACE -H, AVIA -H”. The stick presently does not go to center by itself. What parts do I need to use to get this set up correctly?
- fallout9
- Posts: 5184
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: What gimbal parts for a Gunfighter Pro-L MCG Ultimate
The default springs are more like a holder than a suggested setup, especially for a MCGU grip with extension. For this unit you should go for the max spring, which is 1x #50 and 1x #40 per each axis. Also, Avia Hard cams would be advisable at the beginning, especially if you're using dampers too. You could also try Avia Soft. This guide explains how to set up your base (swap cams, add springs, adjust dry clutch).
Re: What gimbal parts for a Gunfighter Pro-L MCG Ultimate
Thank you. After I posted I went with the #50 springs and the AVIA-S cam. Absolutely appreciate the quality of this product. I already tried to get the #40 springs on as well but the size of the spring barrels was a problem for me to get them to stay on.
Do you move the #50 springs off the groove and closer to the cam to make room for the second set of springs?
Do you move the #50 springs off the groove and closer to the cam to make room for the second set of springs?
- fallout9
- Posts: 5184
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: What gimbal parts for a Gunfighter Pro-L MCG Ultimate
It is recommended to have the stronger spring installed on the inner side. Also, as shown in the guide above, make sure the springs' coils are facing outwards if there are 2 per cam.
Who is online
Users browsing this forum: No registered users and 41 guests