VKB-SIM

Hey All,

I just got my MCG Ultimate with twist adaptor joystick in and it looks as though there may be a defect in my adaptor. Looking at one of the pictures I attached there seems to be two locking pin holes and because of that there is a large amount of sway (deadzone essentially) when placed in the base.

Is this intended? Did I miss something when getting it all together out of the box?

Much appreciated,
Colin Kujan

This, below, is the hole that you have to fit the pin from the base through. After you seat the grip on the base adjust its angle and tighten the fastener so the grip is in desired position. The large hole indicated in pic below provides a 15% offset when installing the grip.
Do not press hard on it if the fastener is not tightened so you won't damage the connection pads on the base. Press gently on the grip while tightening the fastener for better contact.