Hey All,
I just got my MCG Ultimate with twist adaptor joystick in and it looks as though there may be a defect in my adaptor. Looking at one of the pictures I attached there seems to be two locking pin holes and because of that there is a large amount of sway (deadzone essentially) when placed in the base.
Is this intended? Did I miss something when getting it all together out of the box?
Much appreciated,
Colin Kujan
MCG Ultimate With Twist - Twist Locking Pin Quality Defect?
Moderator: AdminGroup
-
- Posts: 1
- Joined: Fri Aug 05, 2022 22:37
- fallout9
- Posts: 5182
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: MCG Ultimate With Twist - Twist Locking Pin Quality Defect?
This, below, is the hole that you have to fit the pin from the base through. After you seat the grip on the base adjust its angle and tighten the fastener so the grip is in desired position. The large hole indicated in pic below provides a 15% offset when installing the grip.
Do not press hard on it if the fastener is not tightened so you won't damage the connection pads on the base. Press gently on the grip while tightening the fastener for better contact.
Do not press hard on it if the fastener is not tightened so you won't damage the connection pads on the base. Press gently on the grip while tightening the fastener for better contact.
Who is online
Users browsing this forum: No registered users and 86 guests