VKB-SIM

Hi all

I have purchased the SEM to go with my THQ. when I connect the SEM using the 4-to-4 JST cable. the THQ won't be recognized by PC.
I have the WWII throttle grip installed on THQ as well and it works fine
The THQ was updated to v2.112 using Config v0.92.33.
Can you help me to make it work please.

With all 3 devices connected press the Default button under the Tools tab, then the Find&AutoConfig button on the Global/External panel. Calibrate all 3 devices (or 2, if the SEM is all digital) afterwards.

Thanks for your prompt response.
When I connect the SEM. It does not appear in VKB Config SW.

It won't until you'll follow the procedure above.

When I connect the SEM-V to the THQ it will not show up in the Config SW.
The blue light is on on the HID and when I press B1 B2 B3 on the SEM it lights up. but no sound notification that a device was connected to PC and they don't show up on the config SW.

Post a pic please with the bottoms up so the connections between modules are visible. Also screenshot with VKBDevCfg displaying the device to see what software/firmware versions you're using.

This a pic showing the connection

This pic shows the SW and Firmware.

THQ to GNX connection pic too please.

Also, those cable have to get positioned as in the videos, otherwise they'll get damaged.

What do you mean?
I am using the HID board so it is a direct connection to USB from THQ to PC.

Right, sorry

It's a firmware issue; flash the attached one, press Default button, Find&AutoConfig button and recalibrate.
And please do something with those cables; the throttle grip cable should be arranged like this and the module connecting cable should be pushed down, between the 2 detent blocks.

The newer firmware did solve the issue. Thank you for your support Fallout9.

P.S. I did tidy up the cables in accordance to the video before closing the covers.