VKB-SIM

Zdrastvutya, I connected my Gunfighter for the first time today.

I have the Gunfighter MKIII MCE with Twist
Firmware version is 2.09.0 XT
I have not changed the springs or cams - they are what was installed at the factory
I'm using VKB Device Config version 0.92.17

When I go to Calibrate>Axes 1>Default, it displays Default PAR, Get Device, Read Data Ok. Then I click Start Calibration but only the roll and pitch axes are detected. The brake, ministick movement is not detected. In External Devices, two bases are displayed and one stick. The stick has 100% Communication Error Level.

Release the fastener securing the grip to the base until the grip moves around, then press gently on the grip while tightening back the fastener.

Thanks fallout...I'll try that and post results.

Tried that, and it still behaves the same. I notice I have a flashing red light at number 2 and the blue light on the opposite side is also flashing.

What grip do you have exactly, is it the MCG Pro or MCG Ultimate?

It's the pro edition. And thank you again for trying to help.

Oh, I think I flashed the wrong firmware. I'll try it again using the Pro version.

Yup...that was it. Thanks fallout.

Cheers!