Zdrastvutya, I connected my Gunfighter for the first time today.
I have the Gunfighter MKIII MCE with Twist
Firmware version is 2.09.0 XT
I have not changed the springs or cams - they are what was installed at the factory
I'm using VKB Device Config version 0.92.17
When I go to Calibrate>Axes 1>Default, it displays Default PAR, Get Device, Read Data Ok. Then I click Start Calibration but only the roll and pitch axes are detected. The brake, ministick movement is not detected. In External Devices, two bases are displayed and one stick. The stick has 100% Communication Error Level.
Gunfighter MCE MKIII Communication Error Level 100%
Moderator: AdminGroup
- fallout9
- Posts: 5180
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: Gunfighter MCE MKIII Communication Error Level 100%
Release the fastener securing the grip to the base until the grip moves around, then press gently on the grip while tightening back the fastener.
Re: Gunfighter MCE MKIII Communication Error Level 100%
Thanks fallout...I'll try that and post results.
Re: Gunfighter MCE MKIII Communication Error Level 100%
Tried that, and it still behaves the same. I notice I have a flashing red light at number 2 and the blue light on the opposite side is also flashing.
- fallout9
- Posts: 5180
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: Gunfighter MCE MKIII Communication Error Level 100%
What grip do you have exactly, is it the MCG Pro or MCG Ultimate?
Re: Gunfighter MCE MKIII Communication Error Level 100%
It's the pro edition. And thank you again for trying to help.
Re: Gunfighter MCE MKIII Communication Error Level 100%
Oh, I think I flashed the wrong firmware. I'll try it again using the Pro version.
- fallout9
- Posts: 5180
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Who is online
Users browsing this forum: Bing [Bot] and 23 guests