Gunfighter not centering with latest firmware
Posted: Sun May 15, 2022 5:27
Hi there,
I have been using firmware 2.025 with both my Gunfighters + SCG and recently updated to the latest firmware (2.090) + matching VKB cfg software.
After upgrading I noticed my sticks would no longer center at 32767 on the X or Y axis, even with a large circular deadzone (5). It's like the deadzone was being ignored.
I tried using experimental 2.11 firmware with the same result.
I rolled back to 2.025 firmware and my sticks perfectly center at 32767 with a .5 deadzone.
Has anyone else had this problem? Have I perhaps missed something or done something wrong? Obviously I have been able to workaround it by rolling back but I would like to keep up with the latest firmware if possible.
Thank you!
I have been using firmware 2.025 with both my Gunfighters + SCG and recently updated to the latest firmware (2.090) + matching VKB cfg software.
After upgrading I noticed my sticks would no longer center at 32767 on the X or Y axis, even with a large circular deadzone (5). It's like the deadzone was being ignored.
I tried using experimental 2.11 firmware with the same result.
I rolled back to 2.025 firmware and my sticks perfectly center at 32767 with a .5 deadzone.
Has anyone else had this problem? Have I perhaps missed something or done something wrong? Obviously I have been able to workaround it by rolling back but I would like to keep up with the latest firmware if possible.
Thank you!