Hello,
I bought the SEM and FSM-GA and am trying to mount them to my existing aluminum extrusion setup. I have two plates that I want to drill holes into to mount the holes.
I tried searching around for a diagram of the mounting hole locations, but not finding anything. This is just my last ditch effort to find something official before I just measure it out by hand and hoping for the best.
Btw, what screw sizes do the mounting holes use?
Thanks.
NXT Modules mounting holes diagram?
Moderator: AdminGroup
- fallout9
- Posts: 5222
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1225 times
Re: NXT Modules mounting holes diagram?
The holes are M3. For the diagrams have a bit of patience, working on it.
- fallout9
- Posts: 5222
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1225 times
Re: NXT Modules mounting holes diagram?
Hello guys!
Precisely this morning I made some holes in a bracket to put the GNX modules. I didn't need to take measurements the way I did.
http://forum.vkb-sim.pro/viewtopic.php?f=27&t=6618
Precisely this morning I made some holes in a bracket to put the GNX modules. I didn't need to take measurements the way I did.
http://forum.vkb-sim.pro/viewtopic.php?f=27&t=6618
-
- Posts: 5
- Joined: Wed Feb 28, 2024 12:30
- Has thanked: 1 time
Re: NXT Modules mounting holes diagram?
fallout9 wrote:Here we go:
Sorry for waking up a old topic :
Yesterday I bought a FSM-GA with the HID controller to use it as standalone.
The thing is, my whole setup is Virpil based.
My current plan is to make a bracket myself for the FSM-GA for the deskmount.
Now the posted diagram, is this the same for the FSM-GA ?
If not, would it be able to post a same kind of diagram of the FSM-GA ?
-
- Posts: 5
- Joined: Wed Feb 28, 2024 12:30
- Has thanked: 1 time
Who is online
Users browsing this forum: No registered users and 17 guests