VKB-SIM

Hello,

I bought the SEM and FSM-GA and am trying to mount them to my existing aluminum extrusion setup. I have two plates that I want to drill holes into to mount the holes.

I tried searching around for a diagram of the mounting hole locations, but not finding anything. This is just my last ditch effort to find something official before I just measure it out by hand and hoping for the best.


Btw, what screw sizes do the mounting holes use?

Thanks.

The holes are M3. For the diagrams have a bit of patience, working on it.

Here we go:

Hello guys!

Precisely this morning I made some holes in a bracket to put the GNX modules. I didn't need to take measurements the way I did.

http://forum.vkb-sim.pro/viewtopic.php?f=27&t=6618

Thanks for the diagram!

fallout9 wrote:Here we go:

Sorry for waking up a old topic :
Yesterday I bought a FSM-GA with the HID controller to use it as standalone.

The thing is, my whole setup is Virpil based.
My current plan is to make a bracket myself for the FSM-GA for the deskmount.

Now the posted diagram, is this the same for the FSM-GA ?
If not, would it be able to post a same kind of diagram of the FSM-GA ?

From the bottom edge of the case to the hole is 34mm, other dimensions are in the picture.

Thank you very much