VKB-SIM

I currently have the MCG Pro mk II with twist axis and T-rudder pedals. Is there anyway to setup 9 axis?

Current Axis are:
- 2 on pitch/roll
- one on brake
- 4 on hats (2 on each of the MCG pro hats)
- 1 axis on the twist yaw

Is there anyway to use my pedals while all 8 physical axis are in use?

If you are running current firmware, you can move an axis to a second virtual device, allowing you keep all of the axes.

Current firmware and VKBDevCfg - https://vkbcontrollers.com/?page_id=4609

The following is with MCGU, but the process is the same with MCGP. This will move the twist axis onto a second virtual device.
Open VKBDevCfg, change the settings outlined in red boxes, hit set, and recalibrate.

I was late))) Agreed. Tested on SCG Pro+twist. Connected 3-axes pedals. left HAT axes moved to 2nd VC and enabled toe brakes.

Thanks all! Yep this is exactly what I needed, it works now!