Hi there, I'm a little confused by my new purchase.
I have a brand new EVO lefty OTA and an SEM. I've connected the two, but the SEM wasn't getting power, and wasn't detected in Config.
I was using the 4-pin to 3-pin connector cable on the SEM/EVO, as the 4-pin to 4-pin is too short. I had the 3-pin connector plugged into the 4-pin receiver port on the EVO.
I can't see a way to connect using the 4-pin cable. Am I missing something?
[FIXED] Left EVO + SEM issue
Moderator: AdminGroup
- fallout9
- Posts: 5160
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 207 times
- Been thanked: 1217 times
Re: Left EVO + SEM issue
Please use the 3-pin to 4-pin cable, 4-pin end gets connected into the SEM and the 3-pin end into the EVO, this way (one socket or the other):
Re: Left EVO + SEM issue
Cheers, Fallout - I saw what I did wrong. I initially had my cable plugged in at the top 3, not the bottom 3 pins as you've shown above.
When I did try it out in the bottom 3, I forgot to hold the B1,2,3 buttons to enter setup, so assumed it wasn't powered.
All silly mistakes on my part, all fixed now and fully up and running! Thanks for the assist!
When I did try it out in the bottom 3, I forgot to hold the B1,2,3 buttons to enter setup, so assumed it wasn't powered.
All silly mistakes on my part, all fixed now and fully up and running! Thanks for the assist!
Who is online
Users browsing this forum: No registered users and 34 guests