LED programming FSM-GA
Posted: Sat Dec 04, 2021 13:39
Hi,
is it possible to colour the LEDs individually on the FSM-GA?
If so, are there any instructions for this?
I have added User=Developer in the .ini and could also address the LEDs in the VKBDevCfg-C, but after that I am a bit overwhelmed.
The FSM-GA is connected to the THQ
Edit:
OK, i found the two LEDs i wanted to change. It looks like the module can only display green and red, no matter what is set in the software.
Best regards,
InvaderZim
is it possible to colour the LEDs individually on the FSM-GA?
If so, are there any instructions for this?
I have added User=Developer in the .ini and could also address the LEDs in the VKBDevCfg-C, but after that I am a bit overwhelmed.
The FSM-GA is connected to the THQ
Edit:
OK, i found the two LEDs i wanted to change. It looks like the module can only display green and red, no matter what is set in the software.
Best regards,
InvaderZim