Hi,
is it possible to colour the LEDs individually on the FSM-GA?
If so, are there any instructions for this?
I have added User=Developer in the .ini and could also address the LEDs in the VKBDevCfg-C, but after that I am a bit overwhelmed.
The FSM-GA is connected to the THQ
Edit:
OK, i found the two LEDs i wanted to change. It looks like the module can only display green and red, no matter what is set in the software.
Best regards,
InvaderZim
LED programming FSM-GA
Moderator: AdminGroup
Who is online
Users browsing this forum: No registered users and 28 guests