Hello there
I've just received my SEM.
Today I prepared it to be connected.
1) removed the 5 screws
2) removed the bus board
3) installed USB board making sure to connect the 4 pins and adding the 3 screws
4) added the transparent thing where the led is
5) changed the detents for landing gear and flaps
5 bis) closed everything
6) installed the usb c to usb a cable and secured it with the small plate.
7) downloaded VKBDevCfg (v0.92.17)
booted SEM in config mode, set subaddress 1, set detents for landing gear to 2 and none for flaps
9) pressed C1 and disconnected.
10) connected to pc and the application does not show me the SEM (it does show the gunfighter and the gladiator though)
Things I've tried;
Changed the usb port
Changed the subaddress
Disconnected the gladiator
Nothing worked. Any suggestions?
SEM with USB module not recognized
Moderator: AdminGroup
-
- Posts: 51
- Joined: Thu Nov 19, 2020 13:29
- Been thanked: 3 times
- fallout9
- Posts: 5182
- Joined: Wed Oct 03, 2018 20:37
- Has thanked: 208 times
- Been thanked: 1218 times
Re: SEM with USB module not recognized
Remove the GNX HID controller and check on the 4 pin connector.
-
- Posts: 51
- Joined: Thu Nov 19, 2020 13:29
- Been thanked: 3 times
Re: SEM with USB module not recognized
Thanks fallout!
Disassembled, checked the connector and now all is good. Thanks a lot!
Disassembled, checked the connector and now all is good. Thanks a lot!
Who is online
Users browsing this forum: No registered users and 41 guests