VKB-SIM

Hi,

I need some help with the physical connection of the SEM-V, THQ and HID modules.

The attachment shows the layout of my NXT, MK4, SEM-V, THQ and HID modules. If I connect the SEM-V (USB-C port) to the THQ+HID (USB-C port), I don't understand how the THQ can be connected to my PC as the only USB port on the THQ would already be connected to the SEM-V.

For this kind of build you need either a second GNX HID controller so you'll connect both units independently to USB or this cable, which would allow it to connect it internally to the THQ and externally to the SEM-V, leaving the Type-C connector on the THQ free for USB connection.
You could also connect the THQ to the side of the Gladiator NXT and in this case you don't need any extra parts (but you'll need to remove the GNX HID controller from the THQ and put back the original BUS board).

Thank you!