VKB-SIM

Hello!

I have an issue with my SEM which is attached to my Gladiator NXT R.

First here's my system info:
1 - Device model and version: Gladiator NXT R with SEM
2 - Controller Firmware version: v2.085
5 - VKB Device Config v0.92.17

And that's the issue:

• Only the top and lower left landing gear LEDs illuminate when moving the landing gear lever (button #62) down. The lower right (LED #19) does not illuminate.
• This behavior occurred suddenly - when I first set the SEM up all of them went green.
• The LED itself is not broken: tested with TEST/MISC/LED N
• In the LED configuration panel I noticed, that for the mentioned LED (#19) there is no event defined. The other two landing gear LEDs (#17 and 18) are linked to Button 62 (that's the gear down position)
• However, I cannot add an additional line for Button 62 linking it to LED #19.

Please help!

Many thanks in advance!

And what prevents you from scrolling below?

Let me clarify: I certainly did add another line for LED 19 but that is not being accepted somehow. After I send the new configuration, the new line disappears.

That line should be there by default. The missing LED could happen if you changed the axes detents settings without resetting to default and pressing the Find&AutoCalib.
I would say to upgrade to the latest firmware and software, then do a reset to default and click on Find&AutoCalib again.

That did the job! Thanks for the prompt support!

I just posted the same issue, I will try that fix tomorrow!